← Guides

Drone troubleshooting: fixes for the most common problems

Batteries and maintenance · 3 min read

Drone troubleshooting: fixes for the most common problems

Every drone has a bad day. Most problems have simple causes, and simple fixes.

Here are the most common ones, and what to try. Always start with the easy things.

The drone won't take off

  • Is the battery fully charged and seated? Push it in until it clicks.
  • Are the props on the right motors? Swapped props make a drone flip or refuse to lift. See our propeller guide.
  • Is it armed? Many drones need a stick movement or button press to start the motors.
  • Is it in a no-fly zone? Some drones won't take off inside restricted airspace.
  • Does the app need an update or a calibration?

It drifts in a hover

  • Wind. Even a light breeze will move a small drone. Test indoors or on a still day.
  • Trim it. Toy drones without GPS often have trim buttons. Nudge them until it hovers still.
  • Calibrate the IMU (the motion sensor) on a flat, level surface. The app or manual explains how.
  • Weak GPS. Wait for more satellites before take-off.
  • A damaged prop or motor can pull it to one side.

Compass errors

Compass warnings are very common. The compass is easily confused by metal and magnets.

  • Move away from metal: cars, steel structures, manhole covers, reinforced concrete and even some benches.
  • Calibrate the compass when the app asks. Do it away from metal and away from your phone.
  • Don't calibrate unless asked. Calibrating near metal can make things worse.

It won't connect or bind

  • Restart both, controller first, then the drone.
  • Re-link or re-bind the controller using the app or manual.
  • Check the firmware of the drone and controller match.
  • For FPV, check the receiver and radio use the same protocol and settings.

Short flight times

  • Old batteries. Batteries lose capacity with age and use. See our battery care guide.
  • Cold weather. Expect noticeably shorter flights in winter.
  • Wind. The drone works harder.
  • Damaged props. They're less efficient.
  • Extra weight, like prop guards or lights.

Jello or wobbly video

Jello is a wobbly, wavy look in your footage. It's caused by vibration.

  • Check the props for damage and replace them.
  • Check the gimbal dampers (the little rubber balls) aren't split or missing.
  • Check the motors spin freely and quietly.
  • Use a faster shutter speed or an ND filter. See our video tips.

The gimbal is tilted or shaking

  • Remove the gimbal cover before power on.
  • Calibrate the gimbal in the app, on a level surface.
  • Check for damage after a crash. A bent gimbal arm is common.

A motor sounds rough or gets hot

  • Check for hair, grass or sand wrapped around the motor shaft.
  • Spin it by hand. It should feel smooth. Grinding means a damaged bearing.
  • After a crash, check for a bent shaft.

The video signal keeps dropping

  • Keep the antennas pointed correctly. The flat side of most controller antennas should face the drone.
  • Stay in sight. Trees, buildings and hills block the signal.
  • Avoid interference. Busy Wi-Fi areas and power lines can cause problems.
  • Fly closer. You must keep it in sight anyway.

After a crash

  • Check the battery first. Look for dents or swelling. Leave it somewhere safe for a while.
  • Check every prop, arm, motor and the gimbal.
  • Hover-test at head height before flying normally again.

When to get help

If a fix doesn't work, check the manufacturer's support pages and user forums. For bigger repairs, most brands offer a repair service.

And keep notes. If the same problem keeps coming back, notes help you, or a repairer, spot the pattern.