← Guides

Drone propellers: fitting, checking and replacing them

Batteries and maintenance · 2 min read

Drone propellers: fitting, checking and replacing them

Propellers are cheap. They're also the part most likely to cause a crash. A small chip or a prop on the wrong motor can bring a drone down in seconds.

Here's what you need to know.

Why there are two kinds

A quadcopter has four motors. Two spin clockwise and two spin anticlockwise. The props are shaped to match.

This balance stops the drone spinning in circles. It's also how the drone turns. Speeding up one pair and slowing the other makes it rotate.

So every drone has two types of prop:

  • Clockwise (CW) props
  • Counter-clockwise (CCW) props

They look almost the same. They're not interchangeable.

How to tell them apart

Manufacturers mark them in different ways:

  • Markings or colours on the hub. For example, some brands mark one set with a line or a ring.
  • Letters like A and B, or R and L.
  • The shape. Look at the leading edge. The higher, thicker edge leads into the direction of spin.

Each motor or arm usually has a matching mark. Put the marked props on the marked motors.

Fitting them

There are a few common ways props attach:

  • Push and twist. Push down and turn to lock. Common on small camera drones.
  • Screws. Some drones use small screws. Don't overtighten them.
  • Nuts. FPV drones use a prop nut on the motor shaft. Tighten firmly but don't crush the prop hub.

After fitting, give each prop a gentle tug and spin. It should spin freely and not lift off.

Checking for damage

Check your props before every flight. Look for:

  • Chips or nicks on the edges
  • Cracks, especially near the hub
  • Bends or warps
  • White stress marks on plastic

Run a fingertip along each edge. You'll often feel damage you can't see.

If in doubt, replace it. A damaged prop can fly apart at full speed.

Signs a prop is causing trouble

  • Vibration or "jello" wobble in your video
  • A buzzing or uneven sound
  • The drone drifting to one side
  • Motors running hot

Replace in sets

If one prop is damaged, many pilots replace all four. It keeps the drone balanced. At the very least, replace both props of the same pair.

Props also wear out over time. Edges get rough and lose efficiency. Fresh props often give smoother flights and slightly longer battery life.

Balancing

Cheap props can be slightly out of balance. That causes vibration.

For camera drones, using the maker's own props is the easiest fix. For FPV, some pilots balance props with a small balancer and a bit of tape. Most pilots simply buy decent props.

Prop guards

Prop guards are great for beginners and indoor flying. They protect the props, and people and pets, from knocks.

The downsides are a bit of extra weight and more wind catch. Take them off once you're flying confidently outdoors. On some drones, they can push the weight over a rules threshold, so check.

Keep spares in your bag

Always carry a full spare set, and the tool for fitting them. A broken prop shouldn't end a day's flying.